TL Smoother Holder - Anet A8
Description
I'Ve Remixed The Design By Daano To Make The Tl Smoother Holder More Applicable To The Anet A8. Also I'Ve Added Some Holes In The Back To Make A Little Air Flow For Cooling The Circuits. Because They Will Become Hot! In Future I Will Add Small Heatsinks On Top Of The Circuits. As You Can See I Have One Circuit For Motor, So Five Circuits In Total. I Have Used This Circuits [Https://Www.Banggood.Com/It/Tl-Smoother-Addon-Module-With-Dupont-Line-For-3D-Printer-Stepper-Motor-P-1222339.Html?P=9P2408786685201409Uz] Or You Can Buy Five At Once As I Did From Bigtreetech [Https://Www.Banggood.Com/It/5Pcs-Tl-Smoother-Addon-Module-With-Dupont-Line-For-3D-Printer-Stepper-Motor-P-1234636.Html?P=9P2408786685201409Uz]. As I Said Before In Future I Will Add Some Heatsinks [Https://Www.Banggood.Com/It/5Pcs-20X20X15Mm-Diy-Cpu-Ic-Chip-Heat-Sink-Extruded-Cooler-Aluminum-Heatsink-P-1209169.Html?P=9P2408786685201409Uz] To Ensure Enought Cooling. Mks And Bigtreetech Smoothers Seems To Have The Same Dimensions. I Can Said That The Use Of Tl-Smoother Will Make The Motors Run Better And Smootly. Also They Are More Silence And The Print Quality Is A Little Bit Better. I'Ve Printed In Pla. The Case Will Be Attached To The Lateral Acrilic Frame Of The Printer On The Inside With The Stock M3 Screw And Nut. It Doesn'T Affect Bed Or Extruder Movements And The Cables Are Long Enought To Connect All Things. Hope You Find It Useful And Share Your Makes If You Like!
Statistics
Likes
164
Downloads
0