Parameterized Smart compact temperature calibration tower
Description
This Is A Remix Of "Smart Compact Temperature Calibration Tower" By Gaazolee. The Point Is That With The Included Openscad Code, One Can Easily Generate Any Desired Temperature Set To Test For. As I Did Not Want To Start Reverse Engineering The Stls In The Original Design, I Just Imported The Stls Of The Base And One Floor To Openscad And Then Made A For Loop To Stack A Given Number Of Floors With Corresponding Temperature Text. Update 2018-03-24: Updated The Code To Allow Selection Of Which Way The Temperature Are Stacked (Low To High / High To Low). The Selection Is Made With Parameter *Increasing_Temp* With A Default Value Of 0 I.E. The Tower Will Print Starting From The Highest Temperature. Big Thanks To Schlaubi666 For Picking This Up. Update 2018-08-19 (Finally): Fixed The Issue With The Stand Stl Using Netfabb Service. Big Thanks To Tkris_Sd And Steelfab Who Pin Pointed The Issue. My Apologies For Lettings This Updated To Hang For Way Too Long. In The Same Go, I Also Removed The Temperature Marking Present In The Original Floor Stl (That I Originally Just Hid In The Scad Code). Now Just The Correct Temp Number Has To Be Embossed. Update 2018-11-29: Restored The Possibility Of Choosing The Order Of The Temperatures: From High To Low (=The Code A Is) Or From Low To High. Appologies: I Don'T Know How I Managed To Reintroduce This Mistake In My 2018-08-19 Update. Update 2018-12-29: Minor: Just Cleaned Up The Description Text.
Statistics
Likes
82
Downloads
0