10.5 in. Heavy Duty Shelf Bracket (for CR-10 / CR-10S)

Description

This Is Shelf Bracket Remix (Scaled Up) To Allow For The Use Of Qty3 1X4 Planks Of Plywood. 1X4S Available At Any Home Improvement Store Are Actually 3/4" X 3 1/2". This Bracket Allows You To Lay Three Of Them Side By Side For A Sizable And Sturdy Shelf. Thanks To Spencerwebb For The Original Design! This Also Uses Qty3 X 3/16" Screws (Each Bracket) To Install. Be Sure To Screw Directly Into The Studs In Your Walls For Maximum Support. "Shelf Bracket_10.5In" - Very Robust, Sturdy Shelf. Should Support Serious Weight. Printing Dimensions L: 11.96" (304Mm) H: 6.93" (176Mm) W: 0.98" (25Mm) "Shelf Bracket_V2" - Trimmed To Fit A Set Of 2 On A 300Mm Print Bed. Printing Dimensions L: 11.62" (295Mm) H: 8.53" (217Mm) W: 0.98" (25Mm) 0.3 Layer Height With 30% Infill (And 5 Layer Walls) Is Very Sturdy. Probably Unnecessary Unless You'Re Holding Serious Weight. I'Ll Take It Down To 20% Infill On The Next Print.

Statistics

Category

Tags