PrintrBot 1405 E3D Lite6 Bowden Clamp for No Sag Mod
Description
I Couldn'T Find A Suitable Clamp For The E3D Lite6 After Upgrading My Wooden Printrbot 1405 With The No-Sag Mod By Iamjonlawrence, So I Made This. Assuming You Have The Shroud Fan In Place To Keep It From Softening, This Should Hold The Hotend In Place Well Enough, It Also Has A Tail To Reach The Endstop Which Was Previously Done With The Back Of The Extruder Motor. Use M3 Screws And Nuts (The Same That Came With The Printrbot Itself Will Work Nicely.) Source Included.
Statistics
Likes
0
Downloads
0