Anet A6 y belt tentioner New Version
Description
This Is An Upgraded Y-Belt-Tentioner For The Anet A6 3D Printer. The Difference To Other Belt Tentioners Is, That This Version Has The Belt Bearing At The Same Hight As The Original Piece And The Stepper Motor. This Feature Makes The Belt Parallel If You Use A Y-Belt-Holder Like This Https://Www.Thingiverse.Com/Thing:2347849. I Only Changed The Two Frame Pieces To Fit My Requirements. The Backplate And The Screw Are From The Belt Tentioner From Odomlinx. The Frame Piece Version 2 Is A Bit More Rigid Than Version 1. The Downside Is, That You Have To Drill Out The Mounting Holes To Remove The Support Material. If You'Re Not Careful Enough, You Can Make The Holes To Wide. Picture 1: Frame V2 Fully Assembled Picture 2: Tentioner In Printer Picture 3: Frame V1 Picture 4: Frame V2 Picture 5: Comparison With Original Piece Picture 6: Chamfered Hole (Only On Left Frame)
Statistics
Likes
47
Downloads
0