Ultimaker 3 Extended Spool Holders
Description
I Put Wings On My Um3 Extended - The Rear Spool Holder Doesn'T Work Well For My Setup. The Ones You See In The Picture Were Printed On My Makergear M3 Ie - With A .5 Nozzle, .4 Layer Height, And A .6 Layer Width, Via Simplify3D. If You Use These Settings With 4 Perimeters, The Spool Portion Comes Out Very Smooth And Strong. Width Of The Spool Part Is 4.8Mm (Or .6 X 8). The Same Goes For The Base Portion. The Ones In The Pics Are Printed In Petg And Abs - I Wanted To See The Differences In These Materials - Both Printed Nicely And Both Parts Are Very Strong. I'M Sure That Pla Would Work Fine Too.
Statistics
Likes
21
Downloads
0