HC300 Assembly Tool (Minimized)

Description

The Original Hypercube 300 Assembly Tool Does Not Fit The Bed On 200X200 3D Printers So I Remixed It By Cutting On The Sides A Little With Openscad. It'S Width Is Now 180Mm Instead Of 208Mm So That It Can Easily Fit The Smaller Bed. I Also Rotated It 90 Degrees So If You Have Smaller Y Size Because Of Paper Clips It Won'T Collide. The Edges Where I Cut Is A Little Sharp As I Don'T Know How To Make Chamfers Yet Because I Am New To Openscad. But It Was The Easiest Way To Cut It As I Have A Programming Backround Rather Than A Designing One. :) Source File Is Also Attached. To Use/Render It Original Stl Must Be In The Same Directory As The Source File, Whick Is Also Re-Uploaded Here. ;) I Haven'T Printed It Yet, When I Do I'Ll Also Attach A Photo Of It.

Statistics

Category

Tags