Easy-Install Gopro Scuba Mask Mount with recessed nut and support

Description

This Is A Remix Of Jayziggy'S Awesome Original Model. I Made The Following Modifications: * Scaled The Original To .001 In Netfabb So That The Object Would Seem To Be In Mm Units Rather Than Μm. * Meshmixer Was Then Used To Add Some Breakaway Supports So That The Ends Of The Strap Clip Would Print Better On My Single-Extruder Printer. * While In Meshmixer It Seemed Worthwhile To Adjust The Mount Point To Add A Space For A Loosely-Captive Nut. I Found It Difficult To Get Right The Size Or The Cavity For The Nut Within That Application, And Instead Went For A Loose Cavity With Little Protrusions Around The Edges To Hold The Nut In Place. * While Still In Meshmixer, Adjusted The Spacing And Thickness Of The Fins Of The Gopro Mount. The Fact That I Needed To Do This May Indicate That I Need To Recalibrate My Printer --But I Needed A Little More Negative Space Within The Mount For The Fins Of My Gopro'S Mount, In The Print Of The Original I Couldn'T Get The Gopro Mount To Insert Far Enough To Fit The Mounting Screw. A Timelapse Of A Print Can Be Found At: Https://Vimeo.Com/96028830 Edit 08/14/14 -- By Request, I'Ve Added An Stl File That'S Sans Support (All Save 1 That I Couldn'T Easily Remove). I'Ve Also Added The Meshmixer Files For The Original And Sans-Support Version. Edit 08/15/15 -- Added Greycat001'S Optimized And Supportless Version, Named "Gp_Scubamount_V2.3_Nosupport Fixed.Stl"

Statistics

Category

Tags