Anet A8 Shelf Frame Support
Description
My 3D Printer Is On A Shelf With Another Shelf Above It, Anyone With An A8 Knows That The Lack Of Rigidity Is A Major Issue Which Reduces The Print Quality... There Are Lots Of Large Frame Braces But Why Go To That Extent When You Have A Shelf Above That You Can Use As Support... Print 4 X Rod Supports, Use These Along With 8 X M3X30Mm, 8 X M3 Washers And 8 X M3 Nyloc Nuts To Get Your Printer Bolted Down Solid And Square On The Shelf It Is Sitting On... Then You Need To Print 2 X Top Support Brackets, 1 X Top Support Screw Lh, 1 X Top Support Screw Rh, 1 X Top Support Machine Lh & 1 X Top Support Machine Rh. Use A 3Mm Drill Bit To Drill Holes In The Top Plate Of Your Printer To Attach The Part 'Top Support Machine' Then Bolt Through With 3 X M3X16Mm Screws And Secure With Washers And M3 Nyloc Nuts... Screw The 'Top Support Screws' In To The 'Top Support Machine' Plates And Then Place The 'Top Support Brackets' On Top. Unscrew The 'Top Support Screws' Untill The 'Top Support Brackets' Form A Good Contact With The Bottom Of The Shelf Above, Mark The Screw Holes Through The 'Top Support Brackets' On The Bottom Of The Upper Shelf To Mark It'S Location, The Screw In The 'Top Support Screws' Again To Give Clearance To Be Able To Affix The 'Top Support Brackets' To The Underside Of The Upper Shelf Using Self Tapping Screws. Once The 'Top Support Brackets' Are Affixed In Place, Unscrew The 'Top Support Screws' So That Pressure Is Applied Between The Screws And The 'Top Support Brackets' To Apply Tension. Optional Spanner Design Included If You Need To Tighten In A Tight Area... Enjoy Your New Found Frame Rigidity And Increased Print Quality As A Result... Please Leave Any Comments/Suggestions Below... Watch These And Other Items Being Printed Live On My New Youtube Channel: Please Like & Subscribe... Http://Bit.Ly/2Fnoorr Check Out My New Facebook Page: Http://Fb.Me/3Dprintchannel
Statistics
Likes
4
Downloads
0