GoPro handle
Description
This Is 2 Parts To Make Printing Easier. I Make A Lot Of Gopro Mounts But I Was Never 100% Happy With Them, Too Tight, Too Loose, Holes Too Small.... So I Completely Redesigned This One And I May Be Updating My Other Models With This Connector. Also, I Found Something Important For Printing Thin Walled Items Like The Gopro Mounts (Fingers), It'S Important To Only Have 2 Perimeters And Then 100% Infill. I Use To Print With 4 Perimeters But It Turns Out That Is Way Too Weak Because Of Layer Adhesion. See This Thread For The Full Story Http://Forums.Reprap.Org/Read.Php?262,357700
Statistics
Likes
32
Downloads
0