Micro Limit Switch Mount
Description
Needed To Mount A Limit Switch For A Project So Made This :) Its A Very Tight Fit, But I Did Add Holes That Fit A Strand Of Filament So That No Screw Is Needed To Hold The Switch In Place Itself. It Is A Tight Fix So Use A Pliers. With My Printer It Was Overkill As The Switch Needed A Reasonable Amount Of Force To Insert It Uses 3Mm Mounting Screws The Arch Printed Fine On My Printer, Its There To Allow The Cables To Come Out Either Side Once Installed.
Statistics
Likes
8
Downloads
0