Beehive Stand with Leveller and Water Reservoir/Ant Guard
Description
4 Beehive Levelers Are Needed Per Beehive (5 If Using A Liquid Other Than Water) 3 Printed Components Are Required For Each Bee Hive Leveler. -Nut Turner Guide, Which Prevents The Nut Turner From Slipping Under The Hive -Nut Turner Which Turns A Nut That Moves Up Or Down A Bolt Which In Turn Moves That Corner Of The Hive -Foot, Secures A Bolt Which Runs Through The Hive Leveler And Supports The Weight Of The Hive. The Pan Is The 4Th And Optional Component, Which Can Be Replaced By A Similar Container. -Pan/Reservoir Can Serve As A Water Source For The Bees And Prevents The Entry Of Ants(Use Veg Oil Instead Of Water) -Pan Cover Is Recommended If Oil Is Used Additional Required Components Include A 1/4" Diameter, 2" Length Bolt And Nut, And 3 Coarse Thread Self Tap-In Screws(I Used 0.3" Head, 1" Long Coarse Thread). Ps. Longer Bolts Can Be Used If A Taller Stand Is Required. Edit- 03.04.2019 -Replaced Pan Cover For V3 Moat, With One With A Slightly Larger Center Hole Edit- 24.12.2018 -Added Combined Foot And Pan V3 For 1/4" And M6 Bolt Models, And Foot/Pan Cover(Remixed Moat And Cover) From Here Https://Www.Thingiverse.Com/Thing:781265 Edit- 20.09.2018 -Added Pan_Cover -Added Combined Foot And Pan V2 For 1/4" Bolt Model (To Use With Pan_Cover) Edit- 12.06.2018 -Added Combined Foot And Pan For Both M6 And 1/4" Bolt Models (Pan Height Reduced And Diameter Increased, Foot Height Increased) -Added Revised Nut_Turner For Both M6 And 1/4" Models Edit- 08.04.2018 -Added Foot And Nut_Turner Stl For M6 Bolt And Nut Nb. I Noticed Some Slight Movement Of The Bolt Inside The Foot After Installation(Maybe Rocking Caused By Moving Hives During Inspection And Even Wind). You Should Consider Increasing Infill % When Printing Hive_Foot And Newly Introduced Hive_Foot_With_Pan_Combined. Thank You For Your Show Of Support And Appreciation Of This Thing. Optional Tips This Way - Https://Www.Paypal.Me/Zandoli3D
Statistics
Likes
17
Downloads
0