Pimp my Zortrax

Description

I Designed This Kit To Give A Bit Of Personality To Zortrax M200 And M300. I Normally Use My Printers With A Side Spool Holder, So I Have To Load Filament By Left Side Of Printer (Our Left). If You Load Filament Like Me, Print All Clips For Filament With Only Exception Of Piece N.5 (The Side Tube Support) That You Can Find Normal Or With Pneumatic Pcm4-10 Connector (Like Mine In Pictures). If You Load Filament From The Back Of The Printer, You Don'T Need To Print 4 And 5 Clip Models, Prints Only One Of "1 - Ribbon Extruder Clip.Stl" And 3 Of "2 - Ribbon Mid Clip.Stl" (If Needed You Can Print The Third Clip Also, I Never Tried), Obviously You Don'T Need To Print "Back Cap - Tube Support Hole.Stl" And Use The Original One. You Can Print The Top Extruder Using One Color (Using Original Stl) Or Print It In Two Colors Like Me, Printing The "Extruder Front - No Mask.Stl" And "Extruder Front - Logo Mask.Stl". For Best Result, Sand A Bit The Surface Of The Logo Mask And Glue With Cyanoacrylate To The Extruder You Printed. I Have Included The Back Caps As Weel, One To Cover The Back Hole For Original Spool Older, And The Other To Cover The Hole For The Original Filament Tube Support. I Used Also Pla And Abs Without Problem. Use Supports When Needed. Hope You Likes It.

Statistics

Category

Tags