Anet A8 - E3D V6 clone - DirectDrive_Carrier
Description
Hello, This Thing Is An Alternative Carrier For An Anet A8 Printer With The E3D-V6 Clone Hotend. The Radialfan Can Be Attached With The Most Downloaded Fanducts. I Created It Because Of The Pros For A Direct Extruder. The Nozzle Height Is That High So You Can Still Use These Z-Wobble Parts: Https://Www.Thingiverse.Com/Thing:2067676 To Assemble The Hotend With The Extruder I Have Taken A 6Mm Aluminium Pipe And Cut A M6 Screw On It (You Have To Measure Up The Needed Length). I Also Cut The Same Screwsize In The Heatsink Of The E3D V6, After I Enlarge The Drill-Hole To 5.5Mm. In The Aluminium Pipe You Can Bring In The Plastic Pipe Which Was Delivered With The Hotend.
Statistics
Likes
8
Downloads
0