Filament Holder Stick [clips onto 2020] [straight & 90 deg]

Description

This Is My Version Of A Filament Holder. I Have An Flsun Delta, With A Sun Gear Filament Holder On Top. Because I Had To Make An Adapter, My Filament Sits Pretty High Up. All The Other Filament Guides I'Ve Seen Tend To Be Fairly Low Down Or Flat, So I Whipped This Up In Windows 10 3D Builder. Yea Yea, What Am I Doing Using That?! Ultimately I'M Setup Running My Printer From A Crummy Laptop, So Am Not Bothering Installing Anything Better On It. I'Ll Get Around To Using Better Programs, But That Was Quick And Dirty. I Put A Small Notch In It To Make Filament Loading / Unloading Easier. I Sized It To 1.7Mm Based On My Filament Size, So It'S Not Going To Just Flop Out Of This Guideway I'Ve Also Made Up A 90 Degree Turned Version, But Haven'T Had A Chance To Test It Out. The Flat One Needs No Support, But Obviously The 90 Degree One Will. I Printed With At Least 60% Infill Just For Strength Of The Inital Version, But You Could Probably Get Away With Less. I May Add Small Gussets On The Bottom To Strengthen The Connection If It Needs It (Doubt It At This Point).

Statistics

Category

Tags