Hall Endstop Mounts for Delta Printer
Description
These Are Straight-Forward Endstop Holders For Sainsmart Hall Endstop Sensors. I Figured Is Was Time To Take Them Off The Shelf And Design Holders To Adapt Them To A 2040 Aluminum Extrusion Format For A 1M Delta Printer (Https://Github.Com/Electronlove/Deltaspasm). The Carriage Is A Remix From Norwegian Creations Magnetic Ball Joint Carriage With The Addition Of A Mounting Point For Magnets (Https://Www.Norwegiancreations.Com/2018/01/Building-A-Large-Kossel-Delta-Printer-Pt-7-Design-Files/) - Hall Endstop Holders Can Be Printed At 35% Infill (4 Bottom And Top Layers). The Carriages Should Be Printed At 100% Infill For Strength. - I Used A 5/16" Drill Bit (~ 8Mm) To Clear Out The Hole To Glue (Two-Part Epoxy) Magnets In Place. Magnets Were Purchased From Home Depot (0.3" X 0.11" Neodymium Magnets) But The Width Was A Bit Larger Than 0.3" In Diameter. - M3 Screws All Around For Holding The Endstops In Place. With The Magnets, They Trigger At ~ 10Mm Which Should Be Acceptable.
Statistics
Likes
2
Downloads
0