Ender-2 Heat bed cable strain relief "light"
Description
I Printed The Original And It Was Very Heavy And Not Compatible With My Heatbed Insulation. I Use The Following Heatbed Insulation: Http://Amzn.To/2Bgsmay So I Decided To Remix This Strain Relief To Better Fit My Needs. The Weight Is Less Than Half And It'S Working Quite Good. <H2>Print Settings</H2> Infill: 50% Layer: 0,2Mm Support: Yes Raft: No Print-Time: Approx. 1H Used Filament: Nunus Petg: Https://Amzn.To/2Pruc4U I Used The Following Tape On My Cr-10: Http://Amzn.To/2Zxjjgu This Stuff Is Really Great, No Extra Glue Needed, 100% Sticky To The Printed Parts, Which Come Off Really Easily, Even Without Destroying The Tape. On My Ender-2 I Use A 1Mm Carbon Plate Coated With Kapton Tape: Http://Amzn.To/2Npggqi <H3>Extra Tip</H3> Another Very Hot Tip Is To Use Kapton Tape! Here You Get The Glossy Finish And Perfect Adhesion Like With The Blue Tape! Look At This: 200Mm Kapton Tape: Http://Amzn.To/2Npggqi Have Fun! (Amazon.De Affiliate Links)
Statistics
Likes
35
Downloads
0