3D-Freunde V2 Mosfet Holder for Anycubic i3 Mega SD Card Reader
Description
I Was Looking For A Decent Mosfet Holder For My Anycubic I3 Mega For A 3D-Freunde V2 Mosfet And Stumbled Upon This Awesome Holder By Petrzmax (Thank You For That!): Https://Www.Thingiverse.Com/Thing:2758279 I Really Like That It'S Using The Sd Card Readers Screws So That You Don'T Have To Glue Sth. Or Make Changes To The Printer Case, So I Remixed It That It Fits The 3D-Freunde V2 Mosfet. Like With The Original, You Will Need Some Additional M3X8 Screws. Edit: The Screw Holes Of This Holder Are 63 X 53 Mm Apart, In Case You Want To Fit Other Mosfets Than The 3Dfreunde V2. Instructions (After Opening The Bottom Plate): - Unscrew The Sd Card Reader And Leave It Hanging - Screw The 3D-Freunde V2 Mosfet To The Mosfet Holder - Push The Mosfet Holders Tubes Over The Screw Sockets Of The Sd Card Reader - Put The Sd Card Reader Back In Place And Screw It Back On - Connect All The Necessary Cables - Test It! (Can Be Done With The Printer Laying On Its Side, Just Preheat For Pla, Don'T Move The Axes)
Statistics
Likes
57
Downloads
0