Anet A8 Heat Block Sock
Description
My Version Of Diy Heated Block Sock. A Form Was Printed With 0,1Mm Layer Thick And 100% Infill. Don'T Forget To Smear Inside With Vaseline. Recipe For Silicone: Corn Starch + High Temp Silicone. On Youtube You Can See How To Mix It: Https://Www.Youtube.Com/Watch?V=R2Sjgihs5He&T=145S You Also Need: 2 Screws M3X25Mm 2 Screws M3X10Mm (At Least 8Mm) 2 Flat Head Screws M3X6Mm 2 Washers 4 Regular Nuts Or Wing Nuts After A Mold Is Cured, You'Ll Need To Trim It A Bit, And Cut A Hole On Top For An Extruder Tubing. In Addition I Used Diy Vacuum Pump To Get Rid Off Air Bubbles, But It'S Not A Must For You.
Statistics
Likes
26
Downloads
0