Maverick REV-6 cylinder
Description
These Are The Pieces Needed For The Cylinder Of A Maverick Rev-6 Nerf Blaster. Some Gluing And Assembly Needed. The Maverick'S Cylinder Is Far More (Needlessly) Complicated Than The Newer, One Piece, Simpler Cylinders Of Its Sucessors. Added To The Printed Pieces, You'Ll Need A Metal Rod 11.5Cm Long And 2.5Mm Thick; A Small Compression Spring; Two 1Cm Long X 2Mm Thick Screws; And Six 3Cm Long X 3Mm Thick Screws. Dart Pegs Not Included (Get Them Here: Https://Www.Thingiverse.Com/Thing:546629). Air Restrictors Not Included. Padding Of The Plunger Head Highly Recomended Instead. A Full Replacement Cylinder Needs Printing One Of Each Piece Except For The "Rod_End" Piece, That Needs Two Pieces (Obviously, One For Each End Of The Rod). It Also Will Need Two Extra 4Mm Long X 2Mm Thick Screws And Two Washers. Those Wishing Just The Cylinder Itself For A Double- Or Triple-Maverick Mod (Like Https://Www.Thingiverse.Com/Thing:1529446 Or Https://Www.Thingiverse.Com/Thing:508503) Do Not Need To Print The Pieces "Barrel_Side_Front", "Barrel_Side_Rear" Nor "Barrel_Spacer". The Piece "Barrel_Case" Is Optional But Highly Recomended (As The Bottom Plate Screws Into It) Unless You'Re Going For A Cosmetic "Minigun" Look. If Not Used, Some Extra Gluing Will Be Needed. On The Other Hand, You Won'T Need Three Of The Long Screws.
Statistics
Likes
32
Downloads
0