Hold down bracket with 3mm screw hole for Anet A8
Description
Remix Of Anet A8 Hold Down Bracket By Freemark The Thing I Changed Is The Diameter Of The Mounting Hole, I Changed It To 3.2Mm So You Can Use It With 3Mm Screws And Washer. Also Its A Little Less Wide With 12Mm. To Mount Them Just Put A Layer Of Isolation Tape Around The M8 Rod And Put The Bracket On, Then Just Screw It To A Wooden Sheet With Enough Thickness Or Just Screw It Against The Table/Workbench. I Use 24Mm(2X12Mm Glued Together) Thick Mdf And It'S Going Nowhere.
Statistics
Likes
6
Downloads
0