Raspberry Pi ZeroW case
Description
I Really Liked Superrei'S Design. Really Nice With The Hinge. Since I Needed A Case To Lift With My Drone Without Wide Open Ports I Closed The Hdmi And One Usb Port. In The Final End I Would Add Another 0.5 Mm On Th Hinge Side To Make A Smaller Gap In The Hinge.I Was Also Looking To Make It Thinner To Reduce Weight, But I Couldn'T Figure It Out How Do It In Fusion. Finality I Intend To Spray The Inside With Graphite To Screen The Zero To Reduce Interference With The Dji Drone.
Statistics
Likes
6
Downloads
0