Adjustable Fan Duct for Geeetech i3 Prusa Pro B & W
Description
Not Much To Say, Here Is A Fan For The Geeetech I3 Prob And Prow Model With The Steel Carriageplates. Hole Distance Is 24 Mm - Adjustable In Height And Front/Back - Good Airflow From All Sides. - Printable In Any Material Safe Distance So That Duct Doesn'T Melt(Not Even Pla) Recommended Bltouch Sensor Separately Available On Following Link: Https://Www.Thingiverse.Com/Thing:2781315 Leave Your Suggestions In The Comment Section. Update 14.04.2018: Don'T Print High Temperatures(230˚-250) Or Bed Higher Than 65˚ Without The Fan Blowing. After Printing Petg(230˚ Nozzle With 80˚ Bed, And Fan Without Blowing) I Had The Surprise That The Pla Fan(Melted And Deformed A Little Bit. So If You Print High Temp Filament, Print The Fan From Petg Or Abs, Or If You Don'T Need Fan For The Material Remove It.
Statistics
Likes
160
Downloads
0