Lasercut bottle holder for drying
Description
This Is A Bottle Holder For 0.5L Bottles For Drying My Water-Bottle At Work. The Hole For The Bottle Is 4Cm In Diameter So It Should Fit Most Bottles. I Used 4Mm Poppel Finèr (Plywood?), Any 4Mm Wood Should Work. 3 Or 5 Mm Will Probably Work But Will Look A Bit Off... You Can Then Use Sandpaper To Smooth Out The Jagged Edges. Assemble With Care, The Hinge Cuts Might Need To Be Softened With Water.
Statistics
Likes
7
Downloads
0