TronXY X5 Z-Rod reinforcement
Description
Most Tronxy X5-Printers Come With A Lose Hotbed, Guilty Are The Z-Rods, Therefor I Made This Reinforcement. The Models Come In Various Sizes, The 5Mm Version Needs A M4 12Mm Screw + Washer, The 4Mm Version Only Needs A M4 8Mm Screw. You Need To Exchange The Original Motor-Bracket With A Smaller One. Mine Came With A Second Y-Mount, If Yours Didn'T, Print: **Motor_Mount.Stl** The Stepper-Connector Has To Point To The Back Side Or It Won'T Mount. Instructions: 1. Unmount Stepper-Motor. 2. Unmount Rod Holders. 3. Change To Smaler Motor-Bracket. 4. Install Motor ( Don'T Forget To Screw In The Cuppler ) 4. Install New Mounts ( Start From The Top) Because I Was Pleased With The Design From Wbanw: Https://Www.Thingiverse.Com/Thing:2803134 I Included His Design Of The Lower Z-Rod Mount (**Rod_Holder_V2_Top.Stl**) There'S Also Another Version Of A Z-Rod Mount: Https://Www.Thingiverse.Com/Thing:2456962 All Rights Go To Their Original Creators. I Would Appreciate To See Some Pictures Of Your Prints! Greetings From Germany ~Leon
Statistics
Likes
8
Downloads
0