K40 laser light guide
Description
K40 Laser Light Guide Every Time I Use My Laser I Would Need To Use The Test Fire Button To Work Out Where The Laser Would Start Cutting. Since This Burns The Work Piece I Wanted A Simpler Way To Know Where It Was Going To Cut/Engrave. See It In Action Over On Youtube: Https://Youtu.Be/N-Iocycqck4 After Shining A Torch Around In The Laser Path I Found That A Ring Of Led'S Would Provide A Small Ring Of Light Directly Where The Laser Is Aimed. And Although My Mirror Alignment Is Off A Little Bit, It Was Still Able To Produce A Marker Where I Needed It Most. Before Executing A Job, I Can Turn The Laser Off And Turn On The Targeting Light To See Exactly Where It Is Going To Cut. This Worked Out To Be Exactly What I Needed So I Figure Others Can Use It Too :) The Fusion 360 Model Is Included So You Can Change The Led Sizes If They Don'T Fit. I Have Noticed That Led'S Aren'T Exactly 5Mm Any More Depending On Where You Get Them. In Fusion 360, Just Right Click The Inner Cylinder And Select "Push/Pull" To Change The Size, Do This For Each Led.
Statistics
Likes
35
Downloads
0