Kids Batman lamp
Description
This Is For A Led Lamp Bulb Cover. Don'T Be Misled By The Pictures, There Is Still A Lot Of Light Transmitted. Ok, You'Ll Loose Some Lumens But Not That Much In The End, I Used An 8W Led Filament Bulb. Don'T Use A Normal Bulb As The Heat Will Warp Your Pla Parts!!!! I'Ve Printed The Cover In 2 Layers (0.8Mm) And Used Vase Mode. I Tried 0.4Mm But Due To The Flat Surfaces, Warping Is A Real Issue. Use Glow In The Dark For Some Nice Effect After You Turn Off The Lights :-). I'Ve Inserted 2 Files For The Lamp Body So You Can Either Go For Vase Slicing Or Slice The 'Real Thing'. => Only For The Latter One You'Ll Need To Define Supports, All The Rest Prints Without Support, Even The Tubes. Depending The Precision Of Your Printer, I Would Scale Down The Sides A Bit If They Are To Snug. No Screws Needed Except To Fix The Seal Plate. Any Question On The Design, I Will Be Happy To Answer.
Statistics
Likes
24
Downloads
0