Armattan Rooster/Chameleon Ti unify v3 mount
Description
Mount Designed To Use The Rear Standoff Screws To Be Held In Place ,Unlike My Previous Designs That Required The Use Of Lock Nuts Or Being Held Under The Press Nut Brace. Bit Ugly As Far As Chamfers And Smoothness Go Ill Admit,But Its Finally A Design I Came To Like And Doesn'T Take A Lot Of Effort To Remove In Order To Do Work To The Quad.Ill Work On The Looks At Another Point! Edit:5-9-2018 Added A V2 Version With A Piece To Slide The Unify Under Toward The Connector Side.Was Having Trouble With Mine Popping Up And Slightly Sliding Out Of The Mount. Be Very Careful When Putting It In The V2 Mount As The Board Itself Is Small And Fragile, Ive Ripped A Connector Off Before From Applying Too Much Force Notes: -Only Works With The Unify Pro V3 As Others Will Be Too Big -Not Sure Why The Model Placed Itself Sideways When Uploading But Rotate It Before Printing (Obviously) Use With My Rear Ufl Axii Mount And Modified Rxsr Mount For A Near Bulletproof Rear End! Https://Www.Thingiverse.Com/Thing:2865392 Https://Www.Thingiverse.Com/Thing:2870221
Statistics
Likes
49
Downloads
0