Cura (3.2.1) profile Tronxy X5S-400

Description

Someone In The Facebook Group Asked Me To Upload My Profile. Note That This Is For The X5S-400. Not That It Matters Much, Because Even My A8 And Cr10 Are Now Doing A Testprint With This Profile. As Long As You Make Sure Your Basic Printer Settings Are Ok. Note That I Have Only Used This Printer For 3 Days, So The Only Reason I'M Uploading This, Is Because Someone Asked Me To. This Has Zero Infill, But 5 Walls At 0.12 Layer Height. The Small Layer Height And 5 Walls Make Up For Overhangs Up To 75% Without Infill Or Supports. Just Like Any Profile, This Is Not Gospel! If It Fits The Model, You Can Use This. I Made This For Printing Figurines Etc, Not For Parts That Have To Be Strong. Adjust To Your Own Liking. Seam At The Back. Retraction 8Mm @50Mms. Note That This Is Printed With The Marlin 1.1.8 Firmware (See Http://Www.Customize-3D.Com/Tech/Flashing-Tronxy-X5S-Factory-Control-Board-Usb-Cable-Only.Html) And After Pid Tuning Both Bed And Hotend. Printed On Glass With Hairspray.

Statistics

Category

Tags