Wanhao Duplicator 6-Maker Ultimate Hole Plugs
Description
Update 11/17/2019: After All This Time I Realized The Servo Coupling Is Hanging Out Under There Uncovered Waiting For Some Stringy Filament To Wrap Up In. I Added The Coupling.Stl Which Can Be Printed Without Support With The Front Side Printed Down At .2 Layer Height And 100% Infill. [/Update] Cover The Holes Under The Build Plate To Keep Chunks Of Filament And Other Small Items From Going Were They Shouldn'T. Whether You Are Printing Small Parts That 'Pop Off' When You Pry Them Up Or You'Re Working On Things With Small Allen Screws, Set Screws Or Fan Spacers, You Will Want To Keep Those Types Of Things Out Of The Electronics Of Your Printer. Obviously Print These Flat, Bottom Side Up. I Used Pla At 210C/50C, 80Mm/Sec, .2 Layer 50% Fill But You Can Use 20% Too, Save You A Few Minutes.. You Need 1 Back Center Plug, 3 Corner-3 Plugs And 1 Coupler Cover. The Corner-Tiny Is There For Nutcases Like Myself That Want That Last Corner Covered As Well.. Also Check Out My Wanhao D6/Monoprice Ultimate Wire Retainer If You Haven'T Already. Keep Your Wires From Getting Pinched: Https://Www.Thingiverse.Com/Thing:4051105
Statistics
Likes
92
Downloads
0