Dog Biscuit Roller - Paw Print Design
Description
Here'S A Roller I Designed In Tinkercad For Some Homemade Dog Biscuits I Like To Make. The Roller Adds A Paw Print Design To The Biscuits And Helps Give A Visual Guide For Cutting Straight Lines As Well. Please Print With Food Safe Filament. The Roller Didn'T Need To Be All That Long Because I Only Make So Many Biscuits At One Time. I Think It Took Around Three Rolls To Cover The Whole Sheet Of Biscuits With The Design Imprint. The Design Allows Enough Room To Make Nice Cuts Above & Below As Well As On Each Side Of The Paw Print. The Treats I Make Are For My 25Lb & 35Lb Dogs. You Might Want To Size The Roller Larger Or Smaller Depending On The Size Biscuits You Would Want. I Used This Recipe For The Biscuit Mix: Https://Www.Spendwithpennies.Com/Pumpkin-Dog-Treat-Recipe/Print/ It'S Nice Because The Mix Is Thick Enough To Hold The Paw Imprint During The Bake. This Is The My First Original Creation I'M Publishing On Thingiverse! Please Post A Picture Of Your Print Or Biscuits If You Make It. Treat Your Pups To Some Homemade Biscuits :) Enjoy!
Statistics
Likes
88
Downloads
0