TPU/PLA USB Extension Cord Connection Securement Case
Description
Needed A Usb 3.0 To General Usb Connection Securing Device. In My Case It'S A Usb 3.0 Extension Cable To A Garmin Virb X Cable. It Was Designed To Be Printed In Ultimaker Tpu 95A Material, But I Assume Any Nylon Or Flexible Filament Should Print Fine. There Is A Bottom And A Top (Cover?). The Cover Is Designed To Be Friction Held. Sometimes Keeping It Simple Is Easier. Take A Rubber Band And Loop It Over Itself On One End Of A Usb Cord. Ideally, It Should Be On The Connector And Not Where The Wire/Cable Enters The Connector. Take The Loop End And Twist And Reverse Twist On The Opposite Cable Connector Until There Is Enough Tension To Keep Both Connectors Plugged Into Each Other. Please Give A Like If You Like, Download, Print, Or Find My "Keeping It Simple" Idea Helpful. This Thing Was Made With Tinkercad. Edit It Online Https://Www.Tinkercad.Com/Things/Gwiadp4Slac
Statistics
Likes
0
Downloads
0