Z nut holder for use with 3 wheel system
Description
<B>Note: This Remix Is Only Needed If You Are Using Ninjacookie'S Dual Z Upgrade In Combination With Cbmx'S X-Rail 3 Wheel System.</B> Because The 3 Wheel System Is Thicker Than The Original Acrylic, This Moves The X Rail Further Towards The Rear Of The Printer, Pushing The Z Nut Holder Out Of Line With The Z Rod. To Position It Correctly The Z Nut Holder Needs To Be Shorter, However Shortening It Enough Means The M3 Bolt Heads Will Impact The X Rail Itself, So Built Up The Section Under The X Rail To Allow Clearance. Discovered This Issue As I Was Installing Several Upgrades, So With My Priner In Pieces I Had To Macguyver A Temporary Solution To Get Printer Up And Running, Then I Will Be Printing This Update.
Statistics
Likes
9
Downloads
0