Zoom H5 Belt Clip + Hard Case
Description
So, You Got Yourself A Fancy Zoom H5 Audio Recorder But No Way To Clip It To Your Person - No Problem, Just Print This Out. I Printed This In Polycarbonate Because I Am Paranoid And Absolutely Did Not Want It To Fail. Honestly, Good Old Pla Would Probably Do Fine But Might Be A Little Too Stiff. Nylon Might Be A Good Choice As Well. I Would Recommend Buying The 1/4-20 X 1/4" Screw Instead Of Printing It, Otherwise You Are Putting A Lot Of Faith (And Risking A Lot Of Money) On How Well You Can Get Good Inter-Layer Adhesion With Your Printed Screw. I Did Mine In Polymaker Pc+ And So Far So Good, But I Will Probably Replace It Once It Snaps Off And My H5 Crashes To The Ground :) ***Update 7-4-2018 *** I Added A Hard Case To Store The Zoom H5 With The Clip Attached Since It Would Not Fit In The Stock Case. Simply Attach The Bottom To The Sides With A Little Glue And Four M3 Screws After Printing. Also, There Is Some Room In The Case To Add Some Foam Padding If You Would Like.
Statistics
Likes
23
Downloads
0