Raspberry Pi 3 ZipTie Case - Zip-Tie RPi Raspi
Description
I Really Liked The Rpi Case By 0110-M-P But I Didn'T Have The Necessary Hardware On Hand, So I Designed A Case That Uses Zipties Instead. I Always Have Zipties Laying Around, And Some Of The 8" Ties Are Less Than 3Mm Wide And Do A Great Job Of Fitting Through M3 Hardware Holes. I Removed The Mounting Ears From The Original Model, But They Could Easily Be Added Back. I Don'T Tend To Use Them, So This Is A Relatively Sleek, Simple Case That Fits The Models 2 And 3 (I Started With 0110'S Rpi 3 File). I Also Bumped The Sd Card Slot Over By A Millimeter So That It'S Better Centered On The Card Itself. Ymmv This Design Includes The Ribbon Cable And Gpio Knockout Slots From The Original. I Used "Power Gear" Brand Zip-Ties, But I'Ve Seen The Same Sized Ones From Gb, 3M, And Others. Designed From The Original Stl File With Designspark Mechanical. Editable Rsdoc File Is Included.
Statistics
Likes
26
Downloads
0