Trigorilla Board (Anycubic) Stepper Driver Cooling
Description
Drawn With Solvespace, Original 3D Files (*.Slvs) Included. No Support Material Needed, Each Angle Is >45°. The Fan Could Be Mounted With M3 Screws/Nuts. The Print Should Be Paused After 4.6Mm To Place The M3 Nuts Into The Print, The Hexagon Is Then 2,8Mm Deep. With A Layer Height Of 0,2Mm You Have To Pause The Printer After Layer 23 (4,6Mm / 0,2Mm = 23) The M3 Nut To Mount The Fan Duct To The Pcb Could Be Placed/Hold During The Assembly. The Design Is Made For 40X40Mm Fans With A Height Of Up To 25Mm. I Use A Sunon Ha40201V4-000U-999 Fan, Connected To Port Fan1 At The Pcb. The Fan1 Is Enabled, When The Bed Heater Is Enabled (Latest Anycubic Firmware Version). I Use This Fan Duct To Cool Tmc2208 Stepper Drivers (The Printer Is So Silent With These Drivers...).
Statistics
Likes
88
Downloads
0