Don't forget your Towel - Kitchen Towel Holder (Version C)

Description

This Is Probably The Last Version Of The Kitchen Towel Holder/Clip I Will Make. I Have Not Printed This One But It Should Work Since It Is Just A Mash Up Of Parts From The Other Towel Holders. It Was Designed To Move The Clip Up A Bit And The Hook Part Should Keep It From Flopping Around Too Much (That Was The Hope). I Was Going To Make A Flat On The Part That Touches The Oven, So Some Cork Or A Rubber Bumper Could Be Placed There, But This One Does Not Have It. In Terms Of Assembly, Same Applies As The Other Versions, So I Will Just Copy The Info Below: Some Notes: * I Have Not Printed This Version. Post-Printing, Please Make Sure To Get All The Supports Out From The Area Where It Seats. * Thinner Rubber Bands Work Better Than The Thicker Ones, And Tweezers Help/Are Required To Install It. * The Included Tool May Save Some Time And Cursing, It Also Works With The Plastic-Wrap Holder I Remixed So If You Printed That Already, It Is The Same Part. However Since I Have Not Printed This One I Am Not Sure If It Will Help Or Not. * This Will Require A M4X16 Or 20Mm Socket Head Screw And A M4 Locknut. These Hold It Together And The Socket Head Screw Is Needed As It Slides In An Shallow Slot, So It Needs To Be Low Profile (Cap Or Hex Head Screws Won'T Work). * Putting This Together Is Possible, But Requires The Patience Of Somebody Who Grew Up With A Disorganized Lego Collection Stored In One Big Sack (If You Know What I Mean Then You Should Be Qualified To Assemble This). 9-10-2018 - I Updated The Base With A Hole Which May Help Get The Rubber Band In. Assembly: I Added Some Pics Of The Original Model To Show How The Rubber Band Attaches. I Doubled It Over And Looped It Around One Post On The Base, Then Loop The Two Ends One At A Time Around The Post On The Top. The Parts Are Slid Together And Then The M4 Locknut And M4 Socket Head Screw Are Installed - The Nut Goes In The Hexagonal Shaped Hole And The Bolt Goes Through To Meet It From The Other End. The M4 Nut And Bolt Are There To Hold The Parts Together, And Keep Them From Getting Slid Apart Easily. <Strong>Please Keep This Away From Kids And Probably Pets Too Would Be A Good Idea. It Has Small Parts, Pinchy Parts And It Just Make Sense To Be Careful. As Always, Use This At Your Own Risk And If You Do, Please Use With Caution. </Strong>

Statistics

Category

Tags