TrollHunter Amulet of Daylight (Spinning Version)

Description

After Printing Out A Amulet Of Daylight I Decided The Inside Really Needed To Spin. So With An Old Copy Of Nettfab Basic And Tinkercad I Modified The Original Files. Adding A Post, Holes And Cap To Keep It In Place. I Made A Version With The Troll_Topper Attached In Case You Wanted To Print It As One Part. (This Does Require Supports) It Is A Tight Fit But The Center Disk Will Slip In Under The Troll_Toper And Onto The Post. I Noticed That With The Original Version The Inside Disk Would Hit The Troll_Toper Teeth If I Spun It To Fast. So I Made A Second Version With A Extra Mm Of Clearance.

Statistics

Category

Tags