Plant base14.5cmX14.5cm
Description
Here Is A Plant Base Water Catcher Thing ( Not Sure What It Is Really Called). The Dimentions Are 14.5 Cm By 14.5 Cm I Found It Usefull To Print Upright So There Is Less Suport Material Needed Therefore Decreasing The Print Time. (Print Took 14 Hours With My Med Speed Print Settings) Allthough You Are Still Going To Have To Cut Out The Center Support Due To The Other Lip For The Base But I Found That Useing A Sharp Knife Works If You Cut Two Ends Of The Material And Peel.
Statistics
Likes
1
Downloads
0