Heat Bed Glass Holder
Description
Eliminated The Binder Clips From My Heat Bed As An Accessory Fan Shroud I Have Added Would Interfere. These Clips Work With 8" X 8" Glass. You Will Have To Remove The Springs And Knurl Screw Temporarily To Get Them On. The Screws Hold The Clips In Place, But Do Not Go Thru The Clip. Probably Take Longer To Recalibrate The Bed Then Run The Parts. I Happen To Have A Micrometer And Measured From The Bottom Of The Aluminum Plate To The Top Of The Glass Before Removing The Screws So Everything Was Pretty Close. You May Be Able To Take Some Tape And Wrap Around Each Of Four Corners To Maintain Distance Held By Springs. Then You Can Remove The Screws And Springs, Place The Clip, And Re-Install Screws And Springs While Keeping The Height Distance Thru Installation. I Was Afraid To Make The Top Surface Too Thin Since Its Low Melt Plastic On A Heat Bed. I Am Including A Step File For Anyone That Wants To Modify To Fit Their Personal Use. You Can Find My New Bed Leveling Knobs Here: Https://Www.Thingiverse.Com/Thing:3490247, Improved Limit Switch Mounts Here: Https://Www.Thingiverse.Com/Thing:2894364 , And Compact Z Axis Adjustment Here: Https://Www.Thingiverse.Com/Thing:3490367
Statistics
Likes
30
Downloads
0