Creality CR 10 500mm 300mm Frame Braces, spool holder and control box support
Description
These Are My Upgrades For The Creality Cr-10 S5 500Mm Printer. The Frame Braces And Spool Holder Uses M8 Threaded Rods And M8 Nuts. The Spool Holder Uses Two 608 Ball Bearings The Rods Must Be At Least 72 Cm Long For The Two Braces And 15 Cm For The Spool Holder. So If You Buy Two 1M Rods You Should Have More Than Enough. The Parts Are Mounted To The Frame With M4 Bolts And Matching T Slot Nuts. You Will Need 18 T Slot Nuts In All. All Parts Should Print Easily With No Or Minimal Support. The Top Brace Should Be Flipped 180 To Print On It'S Top The Control Box Arms Are Best Printed Laying On Their Sides. I Printed Mine In Abs On A Wanhao 4Ds 0.1 Mm Layer Height To Get A Smooth Finish Although .2 Or More Will Do Just Fine. 4 Outlines, 4 Top 4 Bottom Layers Around 25% Infill For Strength Although Less Will Work As Well Support From Build Plate Only 26Th May 2018 Uploaded Untested Revision To Fit 300Mm Frame Based On Measurements Given In Comments 9Th June 2018 Added Large Size Spool Holder 24Th June 2018 Dual Z Lock For The Cr10-500 I Have Had Some Issues With The Two Sides Getting Out Of Alignment So I Looked At The Possibilities And One Gt2 1220Mm Closed Belt And Two 50 Teeth Gt2 Pulleys Fit Perfectly. You Lose About 20 Mm In Z Travel. It Can Be Reduced To Around 10 Mm If You Flip The Pulleys But I Wanted Them As Close To The Top Bearings As Possible. When You Mount Them Make Sure That You Align Your Bed To Be The Same Height Above The Frame On Both Sides And Only Then Rotate Each Z Axis So The X Axis Are Parallel With The Bed. I Made A Small Bed Level Piece That You Can Print And Use To Help Align The Bed. The 50 Teeth Pulleys Are A Bit Hard To Find Compared To 40 And 60 But I Found Them On Aliexpress. Make Sure They Are 8 Mm Bore. Https://Www.Aliexpress.Com/Item/Gt2-Timing-Pulley-50-Teeth-8Mm-Bore-For-6Mm-Width-Belt-2Pcs-Lot/32660628656.Html?Spm=A2G0S.9042311.0.0.39674C4Dklgvvg It Should Be Possible To Do The Same For The S4 And S3 With 976Mm And 28T And 760Mm And 20T But I Haven'T Confirmed Those Numbers.
Statistics
Likes
183
Downloads
0