Hypercube BEAR x carriage and extruder
Description
Bear Extruder For Bare Minimum Design And Because My Username Is Motherbear In Dutch. "Sensorless_Offset_Bushing" Is Placed Left On The X-Rails On Hc300 To Make X Offset After Homing 0. Print One Of These Or Two If You Want To. If Your Setup Is Not Sensorless (Tmc2130'S) Then You Can Still Use Everything But The Carriage Parts. Bltouch Offset: #Define X_Probe_Offset_From_Extruder 25 #Define Y_Probe_Offset_From_Extruder 0 #Define Z_Probe_Offset_From_Extruder -1.45 (Z Offset Could Differ On Your Probe, Mine Is Original) All Screws Are M3X20Mm Except For The Tensioner Block Which Has 3X M3X25Mm. <B>Update May 10Th 2018:</B> Added "Part_Cooling_Duct_V2.Stl" This Is A Wider, Better Flowing Duct Which Also Directs Air A Little Bit More Down. Hard Print Though At A 0.4Mm Wall Thickness. <B>Update May 13Th 2018:</B> Added "E3D_Clamp_V2.Stl" With Better Dimensions For The Fan Mounting Points And Other Small Tweaks. Tested Some More Different Types Of Cooling Fan Ducts And Found That There Isn'T A Noticable Difference Between Different Types. The Main Thing Is To Have As Much Airflow As Possible Over A Large Area. With This Philosophy I Designed A New Duct Which Is Very Wide And Doesn'T Restrict Airflow. It'S Also A Lot Easier To Print. The File Is "Part_Cooling_Duct_V3.Stl".
Statistics
Likes
30
Downloads
0