Rasie3d Pro2 Spool Holder
Description
Got My Pro2 Last Friday. I Was Not Crazy About The Spool Holder So I Made A New Spool Holder. Took Me A Bit To Get The Clips Just Right But It Finally Fit. I Used Part Of This Thing Linked Below Just Thought I Would Share. Should Fit The N2 As Well. Its Tight But It Will Fit Clear. Uses A 5/16 X 3" Bolt Installed After The Clip Goes In. Also Need 2 608Z Bearings But You All Probably Have Some Lying Around From The Fidget Spinner Bubble :) Https://Www.Thingiverse.Com/Thing:1729239
Statistics
Likes
9
Downloads
0