Remix of Buddha Night Light
Description
I Really Liked The Buddha Night Light But Was A Bit Disappointed When I Printed It Out And Put A Light In To To Discover That It Only Lit Up The Bottom Half Of The Model. So I Took The Model Into Meshmixer And Hollowed Out The Entire Model (Using 2Mm Thickness Walls) And Removed The Original Interior Hollow Channel Created For The Tealight. I Also Reduced The Size Of The Tealight Hole Slightly (From 40Mm To 39Mm) To Make The Light Fit A Bit Tighter. I Also Removed A Little Of The Base Because It Appeared To S3D That It Was Not Completely Flat. I Printed This Using Priline Pla White.
Statistics
Likes
23
Downloads
0