50mm Wanhao Duplicator i3 v2.1 Rear blower V2
Description
Two Options: Standard - This Is For Started Duplicator Bearing Blocks - 5Mm Offset Recessed Bearing - 20Mm Offset This Is Version Two For My Blower. Changes Are: Larger Circunference Around The Nozzle Air Shield To Keep It Away From The Heating Block. It Only Uses 50Mm Blower. You Can Detach The Blower In One Piece. No Need To Detached The Blower. Just Undo 2 Screws. I Recommend Using A 2.5 Or 3 Mm Drill Bit To Clean Up The Exit Holes. Not Necessary But It Helps. I Ran A 10 Hour Print At 255 Degrees And The Shield Is Performing Well. No Deformation Or Melting Due To Proximity To The Heater Block Please Provide Any Feed Back. This Is Version 1: Https://Www.Thingiverse.Com/Thing:2482838 .2 Layer Height Nozzle .4 I Recommend 8 Line Skirt With An Off Set Of .25 Or 0 To Help With Bed Adhesion. I Recommend 2 Outlines. You Can Add Support Between The Two Base. I Printed It Petg And The Bridging Is Not The Best. That Is Why I Added Support Just In That Area. The Rest Of The Blower Does Not Require Any Support.
Statistics
Likes
8
Downloads
0