600TVL micro camera tilt mount for ZMR-250 frame
Description
This Is A 600Tvl Micro Camera Tilt Mount For Zmr250 Frame, Sg90 Servo Controlled, For Fpv Custom Build Quadcopter. The Camera Itself Is Available In Many Stores (E.G. Banggood), Small Dimensions (12.5X12.5Mm) And Low Price Make It Ideal For Beginners. I Could Not Find Low Profile Design, Which Can Be Mounted Under Flysky Receiver And At The Same Time Being Able To Tilt Camera Forward Far Enough To See The Ground When Hovering Or Landing. As A Pilot I'M An Absolute Beginner And I Needed It Really Badly, So I'Ve Designed It From Scratch In Openscad. Before Mounting The Camera, Remove Microphone And No Longer Needed Audio Cable (I Have Replaced All Original Cables As They Seem To Be Too Rigid). Then Mount It Inside Frame Using Hot Glue On Pcb Edges, Leaving Enough Open Space For Proper Cooling. It'S A Good Idea To Glue The Cables As Well, 'Cause The Solder Pads That Keep Them In Place Are Rather Weak. And Don'T Forget Use 5V Power Source For The Camera! For Both: Camera Frame Axis And Servo-To-Frame Connecting Rod A 1Mm Piano Wire Can Be Used Or (Like Me) You Can Use Wire From Straightened Paperclip. Warning: In My Build Zmr'S Top Plate Is Actually At The Bottom, So Check The Position Of Mounting M2.5 Screw According To Your Build. The Position Can Be Changed By Editing Openscad Source Or You Can Just Drill New Holes Where Needed. Flight Controller Software Configuration Examples Can Be Found On Youtube. Just Search "Pitch Camera Gimbal". For Visualization Purposes I'Ve Used Sg90 Servo Model Created By Jens R Aka "Tecdroid" ( Https://Www.Thingiverse.Com/Thing:1034309 ) - So All Proper Credits Go To Him.
Statistics
Likes
11
Downloads
0