2 1/4 ventilation pipe splitter
Description
I Designed This So That The Ventilation Pipes For A Shopbot Desktop Could Fit Over The End Pieces But They Are Standard 2.25In Pipes (Inner Diameter). There Are 3 Parts To Print; 1.) Y Splitter: The Main Part (Print One Per Set) 2.)Y Adapter: The Smaller Tube Which Is Used To Create A Channel To Fit The Stopper Into (Must Print One Each Of The 3 Openings). The Tabs On The End Are Used For Lining Up The Pieces, I'D Recommend Superglue. 3.) Y Closer: The Flat Piece That Closes Off Each Pipe After The Other Two Parts Have Been Connected (Print 3 For Each Opening). Since This Is An Important Piece I Wouldn'T Recommend Anything Less Than 50% Infill, 75% In Good And 100% Is Best Case Scenario. Supports 100% Needed For Every Print, No Acceptations. As Well I Always Add The Solidworks File If Possible, I Have Had Trouble Opening These From Thingaverse But I Believe It'S Only Because I Have An Only Version. In Order To Fit The Print Onto My Makerbot Replicator + I Had To Split The Print In Half So I Made A Shorter Version (Y Splitter Sm) The Slit Into A Left And Right Model Which Will Be Connected After The Print And All Other Parts Will Be The Same.
Statistics
Likes
10
Downloads
0