Kitchen paper towels dispenser box
Description
The Very Quick And Simple Design Of Paper Towel Dispenser. The Purpose Of That Freehand "Zigzag " Hole In Door Is To See How Much Towels Are Left Inside. The First Idea Was Print Filling For That With Some Transparent Material, But I Have No Idea What'S Wrong With My Cura Settings, When I Set 100% Filling, Printer Does Not Print Exactly Nice 100% Transparent, But It Keep Some Crossing Pattern Filling With Tiny Gaps And That Was Far From Transparent. Then I Change Setting To 0%, But It Still Keep Filling With Some Pattern, Maybe 1 Or 2%. Result Was Again - Not Transparent. So I Gave Up To Play With That And Zigzag Hole Is Unfilled For Now, As You Can See On Photos. Maybe When I Figure What'S Wrong, I'Ll Print New Filling. The Box Is In 2 Version. Because Is Bigger Than Printbed Of Most Printers (Max. Area Is Somewhere Around 220X220Mm), I Cut Box Into Half And Each Half Have Own File. There Is Also Full Version For Those Who Have Bigger Printer. Door Keep Closed By Two 5X5Mm Round Neodymium Magnets, As You Probably Noticed Holes In Door And Box Corners. There Is Also Another Version Of Door Without Zigzag Hole, So You Can Put There Your Own Pattern - Or Nothing :) I Also Suggest To Drill Tiny Holes On Door Axles And Put There Screw Or Some Sort Of Axle, Tiny Metal Rod Or Anything Such That. Just To Keep Door In Place Whan You Open It. It'S Up To You. I Also Did Not Made Any Mounting Brackets, Holes For Screws Or Anything Such That. It'S Purely Up To You Where And How You Mount It, So Any Adjustment It Up To You. The Wall Tickness Of Box Should Be Enough To Hold It With 2 Or 4 Screws On Top Or Rear Wall. Enjoy It!
Statistics
Likes
41
Downloads
0