Power Plug Case for Mounting on 2020 Aluminum Extrusions
Description
This Is My Mount For The Power Connector Of My Hypercube Build. I Use This Power Connector With A Switch: Https://Www.Banggood.Com/3-In-1-Fuse-Power-Supply-Socket-For-Makerbot-Ultimaker-P-1051419.Html However I Replaced The 2 Pin Switch With A 4 Pin Switch To Break Both Power Lines To Ease My Mind. Got Mine From Here: Https://Www.Ebay.De/Itm/Wippschalter-H8550Vbaca-Schalter-2-Polig-Ein-Aus-10A-250V-Ac-Schwarz-I-O-855226/183034200775 You Need: - 2 8Mm M5 Screws - 6 M3 Screws (Length: 5Mm And Above Up To ~20Mm) The Holes For The M3 Screws Are Threaded. In The .Zip File Are Other Iterations Of My Design Where I Did Not Enclose The Internal Connections. This Makes The Housing Thinner And You Can Use Cable Connectors But You Have More Wires Outside. I Finally Decided To Use A Full Enclosed Version. The Wires Need To Be Soldered There. The Cable Hole Has A Diameter Of 9Mm. The Housing Needs To Be Screwed To The Extrusions Fist Before Inserting The Connector.
Statistics
Likes
88
Downloads
0