Extrusion/Bridging Test
Description
After Wondering Why Both Repetier And Marlin G-Code Flavors Printed Vastly Better On The Anet A8 When Sliced With Cura 3.2.1 Versus Reprap G-Code Flavor, I Made This Small Test Piece To Produce Prints That I Knew Would Fail With Reprap On My Printer But Actually Managed A Passable Print With Both Of The Others Despite A Decent Sized Bridge Resting Atop .5Mm Pillars. The Examples In The Pictures Were Printed With Makergeeks Raptor Pla @ .2 Layer Height At 225C. This Was My First Print With The Filament And It Has A Higher Suggested Temperature Than What I Usually Use So No Optimizations Or Tuning For It Have Been Done Yet. Speeds May Also Have Been Slightly High For The Model As Well Since I Just Finished Spending The Last Week Or Two Printing Blocks For The We The Builders Project. Didn'T Have Any Bananas For Scale So Used A Us Quarter Dollar Coin. After Seeing How Much Stringing I Got Printing One After The Other I Think This May Work As A Decent Retraction Test As Well For Me To Use In Tuning Once I Get Time To Do My Am8/Mgn Hybrid Rebuild And Switch To A Bowden Setup.
Statistics
Likes
9
Downloads
0